Serving Inland Empire Area, San Bernardino, Riverside, Hemet
Case Studies
Case Studies - Page 2
AQS was called out for low airflow downstairs. The Tech found the compressor wasn't operating and condenser needed replaced.
The unit was running all day long and not cooling the home to its set temperature and it would periodcally trip the breaker.
A/C unit was not cooling the home. We found that the condenser motor has seized up.
A/C system was operating but the homeowner requested for us to complete full inspection on the A/C condenser.
Found multiple issues with the unit, best recommendation was to replace the furnace. When installing a furnace with a base, you have to seal the base with duct board to make...
Homeowner called us out stating that the ac system was not performing well. After full diagnoses of system AQS technician found that system was leaking freon. Condenser was...
AQS was called out for a no heat call and found that the ignition module was not operating proceeded to recommend replacement.
Unit not heating, found control board with burn resistors.
This unit was not heating the home. Gas valve become stuck. The valve was no longer opening and closing.
The furnace was working just the night before. When the homeowner tried to turn it on in the morning, the furnace did not turn on.
AQS was called out for a not cooling call we completed a system analysis and gave client repair, rebuild or replace options.
The furnace was not heating the home. Found a burnt resistor on the control board.
Previous client that AQS install mini split HVAC system in and home owner wanted to add uv light protection.
AQS arrived for a no heat call after technician completed their diagnoses recommended replacing the furnace.
Homeowner was experiencing low air pressure coming out of her vents.
our service area
We serve the following areas
Contractor ID: 929419